AMM170TK2/AMM17TK2/AMM18TK2/AMM19TK2/AMM19TK2(HB) 9
Warnings
1.Read the operating manual thoroughly and be familiar with its contents prior to using this equipment.
2.Carefully unpack the unit and check if any damage occurred during shipment.
3.Should any solid object or liquid fall into the panel, unplug the unit and have it checked by qualified personnel before operating it any further.
4.Uplug the unit if it is not to be used for an extended period of time. To disconnect the cord, pull it out by the plug. Never pull the cord itself.
5.Be a qualified physician, having complete knowledge of the use of this equipment.
6.Test this equipment prior to a surgical procedure. This monitor was fully tested at the factory before shipment.
7.Avoid removing covers on control unit to avoid electric shock.
8.Attempt no internal repairs or adjustments not specifically detailed in this operating manual.
9.Pay close attention to the care, cleaning instructions in this manual. A deviation may cause damage (refer to the Cleaning section on page 14).
10.DO NOT STERILIZE MONITOR.
11.Read the entire instruction manual before assembling or connecting the camera.
12.Do not place the monitor or any other heavy object on the power cord. Damage to the cable can cause fire or electirc shock.
13.Monitor with power supply is suitable for use in patient environment.
14.DO NOT stack more than 8 boxes high
This equipment has been tested and found to comply with the limits for medical devices in IEC
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to other devices in the vicinity. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to other devices, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
-Reorient or relocate the receiving device.
-Increase the separation between the equipment.
-Connect the equipment into an outlet on a circuit different from that to which the other device(s) are connected.
-Consult the manufacturer or field service technician for help.
