Regulatory Information
Electrical Safety Information
A)Compliance is required with respect to the voltage, frequency, and current requirements indi- cated on the manufacturer’s label. Connection to a different power source than those specified herein will likely result in improper operation or damage to the equipment, or may pose a fire hazard if the limitations are exceeded.
B)There are no operator serviceable parts inside this equipment. This equipment generates haz- ardous voltages that constitute a safety hazard. Service should be provided only by a qualified service technician.
C)This equipment is provided with a detachable power cord that has an integral safety ground wire and
1)Do not substitute the cord with any cord other than the provided approved type. Under no circumstances use an adapter plug to connect to a
2)This equipment requires the use of the ground wire as a part of its safety certification. Modification or misuse can provide a shock hazard that can result in serious injury or death.
3)If there are any questions about the installation prior to connecting the equipment to mains power, contact a qualified electrician or the manufacturer.
Emissions and Immunity Information
A)Notice to Users in the United States: This equipment has been tested and found to comply with Part 15 of FCC Rules for digital devices. Models with internal touch controllers meet Class B limits. Models without internal touch controllers meet Class A limits. These limits are designed to provide reasonable protection against harmful interference in a residential installa- tion. This equipment generates, uses, and can radiate radio frequency energy, and if not installed and used in accordance with the instructions, may cause harmful interference to radio communi- cations.
B)Notice to Users in Canada: This equipment has been tested and found to comply with radio noise emission limits as established by the Radio Interference Regulations of Industrie Canada for digital devices. Models with internal touch controllers meet Class B limits. Models without internal touch controllers meet Class A limits.
C)Notice to Users in the European Union: This equipment has been tested and found to comply with the requirements of CE marking for Information Technology Equipment as required by: Low Voltage Directive 73/23/ECC and standard EN 60950; EMC Directive 89/336/ECC, and per standard EN 55022, models with internal touch controllers meet Class B limits, and models without internal touch controllers meet Class A limits.
D)General Information to All Users: This equipment generates, uses, and can radiate radio fre- quency energy. If not installed and used according to this manual, the equipment may cause interference with radio and television communications. There is, however, no guarantee that interference will not occur in any particular installation due to
1)In order to meet emission and immunity requirements, the user must observe the fol- lowing:
a)Use only the provided I/O cables to connect this digital device with any computer.
Elo Entuitive Touchmonitor | CRT Rear Mount User Guide - 39 |
