Attach the Back Cover
•When you have finished connecting your touchmonitor, bring the three cords together at the back of the monitor.
•Place the back cover on the back and pull the cords through the cut out of the back cover.
•Replace the four screws and tighten them securely. Be sure not to over tighten the screws.
•Your touchmonitor has no power switch. Power on your monitor using the power switch of the surge protector, and check that the power LED is on. If not, refer to Chapter 4, Troubleshooting.
•After a brief pause the picture should appear. If necessary, adjust the front panel controls according to your personal preference (see Chapter 3).
•Insert the Elo TouchTools
Note: If this monitor is intended to be used in an existing system, the driver software may already be installed by the system manufacturer. Skip to Chapter 3.