9.DAMAGE REQUIRING SERVICE - The unit should be serviced by qualified service personnel when:

a.The power-supply cord or plug has been damaged.

b.Objects have fallen into, or liquid has been spilled into the unit enclosure.

c.The unit has been exposed to rain or moisture.

d.The unit does not appear to operate normally. Only use the units and controls as described in this manual.

e.The unit has been dropped, or the enclosure damaged.

f.The unit displays serious changes in its performance.

10.SERVICING - The user should not attempt to service the unit beyond that described in the user operating instructions. All other servicing should be referred to qualified service personnel.

11.CLEANING - Disconnect from mains power supply before cleaning. Do not use liquid or spray cleaners, only use a damp cloth. Follow the care and maintenance instructions in this manual.

12.LIGHTNING - During lightning and longer periods of non-use please disconnect from mains power supply and antenna.

13.SAFETY CHECK - After servicing the unit ask the customer service for a safety check.

14.OVERLOAD - To avoid fire and electric shock do not overload wall outlets and convenience receptacles.

15.ELECTROSTATIC DISCHARGE - Disconnect from mains power supply and remove batteries if unit malfunctions. Reconnect after a short time.

IN-DASH MOUNTING

Precautions

After the wiring of all other connections connect the power wires.

The battery cable (RED) must be connected absolutely to the positive clamp (+) of the battery.

To protect against short-circuits insulate all exposed wires/leads.

After the installation secure all loose wires/leads.

Preparations

Before the final installation of the unit first connect all wires and check if all connections were done correctly and the unit operates faultless.

Disconnect the ground lead from the negative pole (-) of the battery.

Select the mounting location where the unit will not interfere with the normal driving function of the driver and no danger for passengers during emergency braking exists.

Consult your nearest dealer if the installation needs the drilling of holes or other modifications of the vehicle.

Mounting aperture

If a suitable mounting aperture in the dashboard is available, as shown in FIGURE A, the unit can be installed into the dashboard.

For such a mounting the dashboard should have a thickness from 4.5 to 6 mm.

Securing of the rear

Fix one end of the assembly strap to the rear of the unit and the other end at the protective wall or another, stable metallic part of the vehicle.

After the mounting the negative (-) battery clamp must be connected again.

 

 

 

 

FIGURE A

 

 

 

 

 

Assembly strap

Mounting aperture

 

 

 

 

 

 

 

 

 

Control shaft opening

Control shaft

 

 

 

 

Flat washer

 

 

 

 

 

 

 

Washer for hex nut

Hex nut

 

 

 

 

 

Flat washer

Dashboard

Trim plate

Rotary knob

14.

 

15.

 

 

 

Page 8
Image 8
Elta 7173N2 manual IN-DASH Mounting, Precautions, Preparations, Mounting aperture, Securing of the rear