GB

INSTRUCTION MANUAL 9050N5 40 CM STANDING FAN

Dear customer,

Please read these Operating Instructions through carefully before connecting your device to the mains, in order to avoid damage due to incorrect use. Please pay particular attention to the safety information. If you pass the device on to a third party, these Operating Instructions must also be handed over.

ASSEMBLY

1

2

3

4

5

6

7

8

9 10 11

12

13 14

c

 

 

15

 

16

 

17

 

18

 

19

1. Front protection basket

20

 

2. Screw to tighten the basket

21

3. Clamping knurled-head screw

 

4. Rotor

 

5. Clamping ring

22

6. Holding clip

 

7. Rear protection basket

23

8. Basket hook

24

9. Hexagon nut

 

10. Handle

 

11.Rotor shaft

12.Motor casing

13.Oscillation switch

14.Vertical joint

15.Knurled-head screw for vertical tilting

16.Switch 0 / 1 / 2 / 3

17.Set screw

18.Hexagon nut (inside) for set screw

19.Height adjusting screw cap

20.Cover

21.Telescope tube

22.Stand tube

23.Power cord with power plug

24.Base plate

7

GB

SAFETY INFORMATION

•Incorrect operation and improper use can damage the appliance and cause injury to the user.

•The appliance may be used only for it’s intended purpose. No responsibility can be taken for any possible damage caused through incorrect use or improper handling.

•Before connecting the appliance to the power source, check that the current and power match those given on the rating plate.

•Do not put the appliance or the plug in water or any other liquid. However should the appliance accidentally fall into water, unplug the appliance immediately and have it checked by a qualified person before using it again. Non-observance could cause a fatal electric shock!

•Never attempt to open the housing yourself.

•Do not place any kind of object into the inside of the housing.

•Do not use the appliance with wet hands, on a damp floor or when the appliance itself is wet.

•Do not touch the plug with wet or damp hands.

•Check the cord and the plug regularly for any possible damage. If the cord or plug is damaged, it must be replaced by the manufacturer or a qualified person in order to avoid a hazard.

•Do not use the appliance if it is dropped or otherwise damaged or if the cord or plug are damaged. In the case of damage, take the appliance to an electrical repair shop for examination and repair if necessary.

•Never attempt to repair the appliance yourself. This could cause an electric shock!

•Do not allow the cord to hang over sharp edges and keep it well away from hot objects and naked flames. Remove the plug from the socket only by holding the plug.

•For extra protection it is possible to fit the electric household installation with a fault current breaker with a rated breaking current of not more than 30mA. Ask your electrician for advice.

•Make sure that there is no danger that the cord or extension cord may inadvertently be pulled or cause anyone to trip when in use.

•If an extension cord is used it must be suited to the power consumption of the appliance, otherwise overheating of the extension cord and/or plug may occur.

•This appliance is not suitable for commercial use nor for use in the open air.

•Never leave the appliance unattended while it is in use.

•Children cannot recognise the dangers involved in the incorrect use of electrical appliances. Therefore never allow children to use household appliances without supervision.

•Always remove the plug from the socket when the appliance is not in use and each time before it is cleaned.

•Danger! Nominal voltage is still present in the appliance as long as the appliance is connected to the mains socket.

•Never use the cord to carry the appliance.

•This appliance is not intended for use by persons ( including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction

8

Page 4 Page 6
Page 5
Image 5
Elta 9050N5 instruction manual Assembly, Safety Information
Page 4 Page 6

9050N5 specifications

The Elta 9050N5 is a cutting-edge radar system designed for a wide variety of applications, primarily in air defense and surveillance. This advanced system represents a significant advancement in radar technology, combining high performance with remarkable versatility.

One of the standout features of the Elta 9050N5 is its enhanced detection capabilities. The radar is equipped with advanced signal processing algorithms that allow it to detect and track multiple targets simultaneously, even in cluttered environments. This is particularly important in modern combat scenarios where the ability to distinguish between various threats is crucial. With a detection range of several hundred kilometers, the Elta 9050N5 can effectively monitor and control airspace, making it an ideal choice for military operations as well as civilian air traffic management.

The radar uses phased array technology, which contributes to its agility and rapid response times. This technology allows for electronic beam steering, enabling the radar to track fast-moving objects with precision while reducing the need for mechanical movement. This not only enhances reliability but also extends the lifespan of the radar system, making it a cost-effective solution for long-term use.

In terms of technology, the Elta 9050N5 integrates advanced automatic target recognition (ATR) systems. These systems utilize sophisticated algorithms to classify and identify targets in real-time, increasing situational awareness and facilitating quicker decision-making for operators. This feature is especially beneficial in dynamic operational theaters where threats can evolve rapidly.

Another important characteristic of the Elta 9050N5 is its ability to operate in a diverse range of environmental conditions. Thanks to its robust design and advanced materials, this radar can withstand harsh weather while maintaining performance standards. Its modular architecture also allows for easy upgrades and maintenance, ensuring the system remains relevant in the face of emerging threats.

Furthermore, the Elta 9050N5 is designed with interoperability in mind. It can seamlessly integrate with other defense systems and platforms, enhancing joint operational capabilities. This makes it suitable for deployment within multi-domain operations, where collaboration across different military branches and allied nations is critical.

In conclusion, the Elta 9050N5 is a highly sophisticated radar system that provides exceptional detection, tracking, and targeting capabilities. Its advanced technologies, robust design, and modular nature make it an attractive solution for both military and civilian applications, ensuring it remains at the forefront of radar innovation in a rapidly evolving technological landscape.
Top Page Image Contents