1 AMC-S402 Overview
The AMC-S402 is an Advanced Mezzanine Card (AMC) module which incorporates an enterprise class dual port SAS disk drive onto the module. The module boasts several unique features intended to help embedded systems designers address both thermal and signal integrity design challenges associated with in-chassis ATCA and MicroTCA applications.
The AMC-S402 includes new signal integrity ‘tuning’ circuits to adjust and optimize the high speed SAS serial links to best match the electrical routing environment of your specific ATCA or microTCA backplanes. These signal wave-shape parameters are stored in non-volatile memory installed on the module.
The AMC-S402 was developed as single-width AMC, with ship options for mid or full height panels. All hard drives are 2.5” small form factor, and spin at a minimum 10,000 rotations per minute (RPM). The AMC-S402 also includes a module management controller (MMC).
1.1Features of the AMC Module
The AMC-S402 is an AMC module with the following major features:
∙Accommodates a single 2.5" SAS hard drive
∙Dual path SAS support, AMC Port 2 primary, AMC Port 3 secondary
∙Drive over-current protection
∙General Advanced Mezzanine Card Features
∙Ejector switches for hot swap
∙Wave shape capability, for SAS transmit signals
∙One blue hot swap LED
∙OOS (Out-of-Service) LED
∙ACT LED indicates in-service state and I/O activity
Refer to Chapter 5 “Specifications” for additional details regarding environmental, mechanical, power specifications, as well as reliability and compliance statements.
1.2PICMG Standards Compliance
The AMC-S402 is fully compliant with the following PCI Industrial Computer
Manufacturers Group (PICMG) specifications:
∙PICMG AMC.0 Rev2.0 (See section 5.1.1 for height exceptions)
∙AMC.3 Revision 1. storage signaling option
1.3Products Supported by this Manual
The information in this manual applies to the following Emerson products:
∙AMC-S402-M-146G
∙AMC-S402-M-300G
6806800H60A AMC-S402 Installation and Use | 1 |
