The use of the Module Handle is used in conjunction with the Blue LED. Please refer to the text and table below for more detailed instructions on insertion and extraction.
Figure 3. AMC Module Injector / Ejector Latch
2.7Installing the AMC Module
Use ESD
This section describes a recommended procedure for installing a board module in a chassis.
Wrist Strap
!
Caution
Before you install your module, please read all cautions, warnings, and instructions presented in this section.
Handling modules and peripherals can result in static damage. Use a grounded wrist strap,
Insert the board by holding the Module
Hot swap compliant modules may be installed while the system is powered on. If a module is not hot swap compliant, you should remove power to the slot or system before installing the module.
1.Verify that you have taken the necessary antistatic precautions.
2.Inspect the ATCA carrier board or MicroTCA chassis, and locate the desired AMC slot.
3.Remove the slot filler panel from the selected AMC slot, if necessary.
4.Carefully align the edges of the module with the rail guides in the appropriate slot or carrier card.
6806800H60A | 7 |
