BP7355 PERISTYLE CF100 9/19/07 11:26 AM Page 11
NOTE: Slightly loosen the four screws securing the lower ring brackets to the switch housing assembly.
Operating Your
Ceiling Fan
9. Securely grasp one of the lower ring |
| IMPORTANT | |||||
Fan installation must be completed, | |||||||
posts and raise the lower ring up to one | |||||||
of the lower ring brackets. Secure the | including the installation of the fan | ||||||
lower ring post to the lower ring brack- | blades, before testing of the remote | ||||||
et using a bracket mounting screw | control. | ||||||
(Figure 16). Grasp the opposite post | Your remote control has full control of your | ||||||
and secure the post to the opposite | fan and light. | ||||||
bracket | using a | bracket | mounting | 1. | Restore electrical power to the outlet | ||
screw. |
|
|
|
| |||
|
|
|
|
| box by turning the electricity on at the | ||
|
|
|
|
|
| ||
10. Secure the remaining two lower ring |
| service panel. | |||||
posts to the lower ring brackets using | 2. | To set the desired fan speed, press the | |||||
bracket mounting screws. |
|
|
| HI, MED, or LOW buttons to operate | |||
NOTE: After the lower ring has been |
| your fan on high, medium, or low speed | |||||
mounted, tighten the four bracket |
| (Figure 18). | |||||
mounting | screws | securing | the four | 3. To turn your fan off, press the FAN/OFF | |||
brackets | to the | switch | housing | ||||
| button. | ||||||
assembly. |
|
|
|
|
| ||
|
|
|
| 4. To change the airflow direction of the | |||
|
|
|
|
| |||
Installation of |
| fan blades, press the FOR/REV button. | |||||
| The direction the fan blades turn will | ||||||
Storage Bracket |
| ||||||
| change each time the FOR/REV button | ||||||
A storage bracket is supplied with the |
| is pressed. | |||||
5. To set the level of light brightness, | |||||||
remote control for holding the transmitter | |||||||
when not in use. If you desire to use the |
| press and hold the LIGHT DIMMER | |||||
bracket, use the two screws (supplied) |
| button. The light brightness will contin- | |||||
and install it on a wall that is away from |
| ue to increase then decrease while the | |||||
excess heat or humidity. When installing, |
| button is held down. When the light is | |||||
orient the bracket so that the tab is at the |
| at the desired brightness, release the | |||||
top and away from the wall (Figure 17). |
| button. |
FAN/OFF HI
REMOTE CONTROL TRANSMITTER
TAB
6. To turn the light ON and OFF, press and release the LIGHT DIMMER but- ton. The light will turn ON at the light level previously set (see step 5).
Red light should turn on when any but- ton is pressed. If the light does not come on, replace the battery.
FOR/REV MED
LIGHT LOW
DIMMER
STORAGE
BRACKET
®
Figure 17 | 11 | U.L. Model No.: CF100 |
|