BP7355 PERISTYLE CF100 9/19/07 11:26 AM Page 4
2. Remove the fan motor and housing assembly from the protective plastic bag. Place the fan assembly into the upper foam pad with the top of the motor facing up.
The upper foam pad serves as a hold- er for the fan during the first stages of assembly.
Preset Memory Feature
Your remote control receiver is equipped with a preset memory feature. The receiv- er will remember the light intensity and fan speed when the light and fan are turned off from the wall switch. When the wall switch is turned back on, the lights and fan will resume operation as they were prior to the
General
switch being turned off.
Your Emerson ceiling fan comes equipped | Installation of Battery | |
with a remote control transmitter and a | ||
|
remote control receiver. This remote con- trol systems is designed to control your ceiling fan speed, airflow direction, and light intensity.
NOTE: An optional SW113 Wall Control (not supplied) may also be used with the remote control receiver supplied with your ceiling fan.
1. Remove the battery cover by pressing firmly below the arrow and sliding the cover off the control (Figure 1).
2. Engage the connector in the transmitter with the terminals of a
IMPORTANT
This Owner’s Manual is divided into two sections. The first section,
REMOTE CONTROL PROCEDURES, describes how to install the
BATTERY COVER SWITCH LEVERS
ON |
|
|
|
1 | 2 | 3 | 4 |
CODE SWITCH
operating frequency of the transmitter and receiver. These instructions must be performed prior to the installation of the ceiling fan as described in the second section, CEILING FAN PROCE-
DURES.
BATTERY
BATTERY
CONNECTOR
Figure 1
CODE SWITCH
REMOTE CONTROL TRANSMITTER
REMOTE CONTROL
PROCEDURES
General
The remote control system is designed to |
|
separately control your ceiling fan and |
|
light intensity. There are four push buttons |
|
on the transmitter (HI, MED, LOW, OFF) to |
|
set the fan speed and turn the fan off. The |
|
FOR/REV push button changes the airflow |
|
direction of the fan blades. The LIGHT |
|
DIMMER push button turns the lights on |
|
and off and controls the light intensity. The |
|
red indicator light will illuminate while any |
|
button is pressed, indicating that the bat- |
|
tery is good. | 4 |
Setting Operating
Frequency of Transmitter
and Receiver
Your remote control transmitter and receiver have code switches which must be set on one of 16 possible code combi- nations. The four levers (numbered 1, 2, 3, and 4) on the switches are
1.On the remote control transmitter, locate the code switch just above the battery compartment (Figure 1).
U.L. Model No.: CF100