11.Obtain the 10” hanger ball/downrod assembly and remove the hanger ball by loosening the setscrew in the hanger ball until the ball falls freely down the downrod (Figure 7). Remove the pin from the downrod, then remove the hanger ball. Retain the pin and hanger ball for reinstallation in Step 22. Discard the 10” downrod if using the 4.5” downrod.
MOTOR
COUPLING
SETSCREW (2) | HAIRPIN | |
CLEVIS PIN | ||
CLIP |
PIN
HANGER
BALL
DOWNROD
SETSCREW
Figure 7
NOTE: The longer downrod (10”) furnished with the ceiling fan provides the minimum recommended
CLEVIS
PIN
UPPER
SETSCREW
MOTOR COUPLING
Figure 8
DOWNROD
CLEVIS
PIN
HAIRPIN
CLIP
SETSCREW (2)
foot ceiling. The 4.5” downrod (supplied) is to be used for shorter ceilings.
12.Separate, untwist and unkink the black, white and blue motor 80” motor leads. Route these wires through the desired downrod.
13.Loosed the two setscrews in the motor coupling. Slide the downrod down the wires and seat the downrod in the motor coupling (Figure 8).
14.Align the clevis pin holes in the downrod with the holes in the motor coupling. Install the clevis pin and secure with the hairpin clip (Figure 8). The clevis pin must go through the holes in the motor coupling and the holes in the downrod. Be sure to push the straight leg of the hairpin clip through the hole near the end of the clevis pin until the curved portion of the hairpin clip snaps around the clevis pin. The hairpin clip must be properly installed to prevent the clevis pin from working loose. Pull on the downrod to make sure the clevis pin is properly installed.
15.While pulling up on the downrod, securely tighten the two setscrews in the motor coupling (Figure 8).
NOTE: The two setscrews must be properly installed as described above, or fan wobble could result.
WARNING
It is critical that the clevis pin in the motor coupling is properly installed and the setscrew securely tightened. Failure to verify that the pin and setscrew are properly installed could result in the fan falling.
NOTE: If installing ceiling fan on shorter ceilings and using the 4.5” downrod, proceed to Step 16 and then onto Step 21.
If installing ceiling fan on a minimum recommended
16.4.5” Downrod Installation: Be sure the grommet is properly installed in the coupling cover, then slide the coupling cover on the downrod until it rests on the motor housing. Be sure that the coupling cover is oriented correctly (Figure 9). Proceed to Step 21 to complete assembly.
4.5" DOWNROD
GROMMET
COUPLING COVER
Figure 9
6 | U.L. Model No.: CF830 |