Emerson CF830GES00 owner manual

17.10” Downrod Installation: Remove the grommet from the coupling cover, then slide the coupling cover on the downrod until it rests on the motor housing. Be sure that the coupling cover is oriented correctly (Figure 10).

18.Slide the decorative lower scroll onto the 10” downrod, positioning the lower lip of the scroll into the hole of the coupling cover (Figure 10).

19.Slide the decorative upper scroll onto the 10” downrod, positioning the three interlocking tabs of the decorative upper scroll into the interlocking tabs of the decorative lower scroll (Figure 10).

20.Tighten the decorative upper scroll to the 10” downrod using the supplied 2mm hex wrench (Figure 10).

10" DOWNROD

DECORATIVE UPPER SCROLL

HEX SCREW

INTERLOCKING TABS (3 ON EACH SCROLL)

DECORATIVE LOWER SCROLL

COUPLING COVER WITH

GROMMET REMOVED

Figure 10

21.Position the ceiling cover over the downrod. Be sure the cover is oriented correctly, with the large opening at the top (Figure 11).

10" DOWNROD

CEILING COVER

TIGHTEN HEX SCREW

22.Reinstall the hanger ball on the downrod as follows. Route the motor leads through the hanger ball and slide the hanger ball over the downrod (Figure 12). Install the pin through the holes at the top of the downrod and slide the hanger ball up the downrod, aligning the ball so the pin is captured in the groove in the top of the hanger ball. Pull the hanger ball up tight against the pin and securely tighten the setscrew in the hanger ball. A loose setscrew could create fan wobble.

23.The blue, black, white, and yellow leads exiting the downrod are 80-inches long. Before installing the fan, measure up approximately 6 to 9-inches above the ball/downrod assembly. Cut off excess leads and strip back insulation 1/2-inch from end of leads.

PIN

SETSCREW HANGER BALL

CEILING
COVER	DOWNROD

Figure 12

WARNING

It is critical that the pin in the hanger ball is properly installed and the setscrew securely tightened. Failure to verify that the pin and setscrew are properly installed could result in the fan falling.

24.Install four 40-watt candelabra base light bulbs (supplied) in the uplight sockets (Figure 13).

UPLIGHT SOCKET (4)

40-WATT CANDELABRA BASE LIGHT BULB (4)

Figure 13

25.You have now completed the initial assembly of your new ceiling fan. You can now proceed with hanging and wiring your fan.

Figure 11 7 U.L. Model No.: CF830