EMERSON QUICK START GUIDE
How to Put Your Ceiling Fan Together (pages 10 & 11)
11.Attach one blade assembly to the motor using the two
NOTE: Take care not to scratch the fan housing when installing the blade assemblies.
12.Remove the four switch housing assembly mounting screws from the switch housing plate and retain for future use.
13.Engage the connector of the switch housing assembly with the fan motor assembly connector. The two connectors are keyed and
BLADE FLANGE ASSEMBLY
SWITCH HOUSING MOUNTING PLATE HOLE
14.Position the switch housing assembly on the switch housing plate and align the holes in the switch housing assembly with the holes in the plate. Secure the switch housing assembly by installing the four screws removed previously.
NOTE: To install an accessory light kit, remove switch housing and make light kit electrical connections to blue and white leads marked “For Light” in the switch housing. Follow light kit instructions for wiring and installation. Then reinstall switch housing as outlined above.
See page 10 for detailed instruction of how to connect the blue fan wire to the branch circuit.
SWITCH HOUSING
CONNECTOR
MOTOR CONNECTOR
SWITCH HOUSING
MOUNTING SCREW (4)
SWITCH
HOUSING
ASSEMBLY
MOUNTING
SCREWS (4)
Installation of Wall Control (page 12)
! WARNING
Turning off wall switch is not sufficient. To avoid possible electrical shock, be sure electricity is turned off at the main fuse or circuit breaker box before wiring. All wiring must be in accordance with National and Local codes and the ceiling fan must be properly grounded as a precaution against possible electrical shock.
TO
NEUTRAL
TO FAN MOTOR LOAD
NOTE: Electric connections should be in accordance with the National Electrical Codes and all Local Codes. Before starting, disconnect power to the circuit at the fuse box or circuit breaker panel.
1.Remove the faceplate and screws from the existing wall switch. Pull switch out from wall outlet box.
2.Disconnect wire from existing fan wall switch.
3.Slide the fan control in the OFF position (0).
4.Connect one BLACK wire from the fan control to the fan/motor lead with a wire connector (provided).
5.Connect the other BLACK wire from the fan control to the 120VAC hot wire with a wire connector (provided).
NOTE: Use wire connectors (supplied) to secure electrical connections.
6.Attach the fan control to the wall outlet box with two
7.Position the faceplate (provided) onto the speed control. Using the two
MOTOR LOAD
1.2 AMP MAXIMUM
| BLACK |
3 | BLACK |
4 |
|
2 |
|
1 |
|
0 |
|
TO 120VAC
SOURCE HOT
* For additional installation review full instructions on page 12.
5 | U.L. Model No.: CF905 |