Emerson CF905BS00, CF905GES00 Unpacking Instructions, Tools Needed for Assembly, Materials

This Manual Is Designed to Make it as Easy as Possible for You to Assemble,

Install, Operate and Maintain Your Ceiling Fan

Tools Needed for Assembly

One Phillips head screwdriver	One stepladder
One 1/4” blade screwdriver	One wire stripper

MATERIALS

Wiring outlet box and box connectors must be of type required by the local code. The minimum wire would be a 3-conductor (2-wire with ground) of the following size:

Installed Wire Length	Wire Size A.W.G.
Up to 50 ft.	14
50-100 ft.	12

! WARNING

Before assembly your ceiling fan, refer to section on proper method of wiring your fan (page 8). If you feel you do not have enough wiring knowledge or experience, have your fan installed by a licensed electrician.

Unpacking Instructions

! WARNING

Do not install or use fan if any part is damaged or missing. Call Toll-Free:

1-800-654-3545

! WARNING

This product is designed to use only those parts supplied with this product and/or any accessories designated specifically for use with this product by Emerson Electric Co. Substitution of parts or accessories not designated for use with this product by Emerson Electric Co. could result in personal injury or property damage.

1.Open carton containing fan. Remove top half of styrofoam unit. Remove parts and check to see that you have received the following parts:

NOTE: If you are uncertain of part description, refer to exploded view illustration.

a.Fan motor assembly

b.One ceiling mounting plate

c.One fan housing trim ring

d.One fan housing cover

e.Five fan blades

f.Five blade flanges

g.One switch housing assembly

h.One 4-speed slide wall control with hardware

i.One loose parts bag containing:

1.Sixteen 10-24 x 5/16" washer head blade screws

2.One 1/4-20 x 9/16" captive flange screw with lockwasher (spare)

3.One 8-32 x 5/16" switch cup screw (spare)

4.Four wire connectors

5.One 10-24 x 3/8" Pan head screw (spare)

6.One 10-24 x 3/8" Pan head screw with lockwasher (spare)

7.One balancing kit

NOTE: Place the parts from the loose parts bags in a small container to keep them from being lost. If any parts are missing, contact your local retailer or catalog outlet for replacement before proceeding.

2.Remove the fan assembly from the protective plastic bag. Place the fan assembly into the upper foam pad with the lead wires up.

b.

a.c.

d.

g.

h.

4

3

2

1

0

f.

i.

e.

6