STANDARD WIRING FOR EXISTING
3-WAY CONTROL:
|
| EXISTING |
|
|
HOT | BLK | WALL CONTROL |
|
|
|
|
| ||
|
|
|
| BLACK |
| TRAVELER WIRES |
| LOAD | |
|
|
|
| |
| BLK | BLK |
| BLK |
HOT | BLK |
|
| |
|
|
| ||
| EMERSON |
| EMERSON | BLACK |
FAN/LIGHT |
|
| ||
|
|
| ||
WALL CONTROL | TRAVELER WIRES |
| LOAD | |
|
|
| ||
5. To turn the light on and off, press and release the LIGHT button. The light will turn on at the light level previously set (see step 4).
HI
LIGHT
MED
LOW
FAN OFF
Figure 22
EMERSON®
OFF
Operating Your
Ceiling Fan
IMPORTANT
ON
Fan installation must be completed, including the installation of the fan blades, before testing of the remote control.
Your Fan/Light Wall Control (Figure 23) has full control of your fan and light. However, airflow direction is controlled by a slide switch on the switch housing.
1. Restore electrical power to the outlet box by turning the electricity on at the service panel.
Figure 23
6. If airflow is desired in the opposite direction, turn the fan off and wait for the blades to stop turning. Then slide the reversing switch, located on top of the fan motor assembly, to the opposite position (Figure 24) and turn the fan on again. The blades will turn in the opposite direction and reverse the airflow.
NOTE: Make sure that the ON/OFF slide switch on the Fan/Light Wall Control is in the ON position.
2. To set the desired fan speed, press the HI, MED, or LOW buttons to operate your fan on high, medium, or low speed (Figure 23).
3. To turn your fan off, press the OFF button.
4. To set the level of light brightness, press and hold the LIGHT button. The light brightness will continue to increase then decrease while the button is held down. When the light is at the desired brightness, release the button.
AIRFLOW REVERSING SWITCH
Figure 24
FAN MOTOR ASSEMBLY
14
