Emerson MODEL EM1200 Installation, Never install telephone wiring during a lightning storm

Models: MODEL EM1200

1 16
Download 16 pages 58.99 Kb
Page 5
Image 5

CAUTION (Cont.)

for a long period of time (several months or more) since during this time the battery could leak in the product.

9.Properly discard "dead" batteries as soon as possible since "dead" batteries are more likely to leak in a product.

10.Do not store this product, or the batteries provided with or identified for use with this product, in high temperature areas.

Batteries that are stored in a freezer or refrigerator for the purpose of extending shelf life should be protected from condensation during storage and defrosting. Batteries should be stabilized at room temperature prior to use after cold storage.

INSTALLATION INSTRUCTIONS

1.Never install telephone wiring during a lightning storm.

2.Never install telephone jacks in wet locations unless the jack is specifically designed for wet locations.

3.Never touch uninsulated telephone

INSTALLATION

Choose Your Location

Your unit must be placed on a hard, flat surface and connected to both the telephone wall jack and an AC power source. Allow at least one inch to the rear and four inches above the unit for ventilation.

To Install One 9 Volt Battery

One 9 volt battery (not included) is required to maintain your Outgoing Announcement and recorded messages during a power failure. If there is a power failure and the battery is not installed, both your Outgoing

wires or terminals unless the telephone line has been disconnected at the network interface.

4.Use caution when installing or modifying telephone lines.

Announcement and recorded messages will be lost.

1.Make sure AC adaptor is unplugged from electrical outlet.

2.Open the battery door with a ball- point pen.

5

Page 5
Image 5
Emerson MODEL EM1200 Installation, Never install telephone wiring during a lightning storm, Choose Your Location