OPERATING INSTRUCTIONS
•Make sure that you have fully extended the FM antenna wire.
•Make sure that you have removed the battery spacer from the remote control handset.
•Make sure that you have installed 3 “AA” batteries in the main unit battery back up compartment.
•Make sure that the system is connected to an AC outlet that is always “live”. Do not connect the system to an AC outlet controlled by a wall switch.
Remove The Dummy CD Transit Protection Cards
This system was shipped with a “dummy CD” transit protection card in each of the
Press the 
STANDBY button to turn the system ‘On’.
Then press the OP/CL or 
OPEN/CLOSE button to open the CD door. Remove the 3“ dummy CDs and discard them.
Press the OP/CL or 
OPEN/CLOSE button again to close the CD door.
General Controls
Most of the main functions of this system can be operated by the controls on the front panel of the main unit, or by the buttons on the remote control handset. If a specific function can only be operated by the remote handset, or by the front panel controls, this will be clearly indicated in the instructions.
When operating this system with the remote control handset make sure that the IR (Infrared) transmitter on the front of the remote handset is pointed at the remote sensor on the front panel of the main unit. The effective operating range of the remote control is approximately 15 feet. Please note that bright sunlight or room lighting may interfere with the remote control operation. If the remote is not operating properly try reducing the brightness of the room or moving closer to the main unit. If this does not solve the problem, it may be time to change the remote control battery.
18
MS3111M_112306.p65 | 18 |
23/11/2006, 10:44
