Setting The Clock
When the system is connected to an AC outlet the time display will show “AM 12:00”.
NOTE: Although it is not necessary to set the clock in order to listen to the Radio or CD player, the clock must be set correctly if you intend to use the timer to turn the system ‘On’and ‘Off’automatically.
Set the clock as follows:
1.) Press the MEMORY(CLK. ADJ.) button on front panel or MEMO(PROG) button on remote control once. The ‘Hour’digits begin flashing.
2.) Repeatedly press the 
or 
buttons on front panel, or remote control to adjust the display to the correct hour, AM or PM.
3.) Press the MEMORY(CLK. ADJ.) button on front panel or MEMO(PROG) button.
The ‘Minute’digits begin to flash.
4.) Repeatedly press the 
or 
buttons on front panel, or remote control to adjust the display to the correct Minute.
5.) Press the MEMORY(CLK. ADJ.) button on front panel or MEMO(PROG) button on remote control again.
Only the colon “ : ” continues flashing.
The clock begins to run.
NOTES: The display will always show the time when the system is in the Standby (Off) or AUX mode.
21
MS3111M_112306.p65 | 21 |
23/11/2006, 10:44
