„CLD-AM: NOx

„External failure

„External maintenance

„and further functions, depending of the analyzer module selected.

·Select the function with the 8 -key or the → -key:

The display will go back to the menu "DIO-Module Inputs" automatically. The function selected will appear in the line "Signal name".

The last four lines of variables in the menu "DIO-Module Inputs" only display some adjustments of the DIO input selected! They are not available:

¨"Slot ID:" displays the tag number of the DIO board selected. If there exist several DIO modules in the platform you can change to the setup menu of each with the F3 key. The tag number of the DIO board selected will appear in the line "Slot ID".

¨"Signal name:" displays the signal selected for the current DIO input.

¨"Signal level:" displays the status of the signal selected.

¨"Signal comes from:" displays the source module selected for the current DIO input.

Configuration of the DIO module outputs:

1)Select the output number:

·Press the 8 -key or the → -key in the line "Outputnumber" of the menu "DIO-Module Outputs" and adjust an output number (1, ... , 24) with the − -key or the ↓ -key.

·Confirm the number selected with the 8 -key.

2)Choose the module:

·Change with the ↓ -key to the line "Choose module...".

·Change to the submenu "Analyzer Modules" with the 8 -key or the → -key. All modules joint to the platform or to the MLT analyzer and the control module will be available:

MLT25/CH2/R2

95.00 ppm

-- Analyzer Modules --

Control Module

MLT25/CH1

MLT25/CH2

MLT25/CH3

MLT25/CH4

MLT25/CH5

Measure

 

<<<

Back...

>>>

F1

F2

F3

F4

F5

5 - 96

NGA 2000

90003482(2) [NGA-e (MLT-Software 3.2.X)] 07/98