5 Analyzer and
If you press the 8
TAG | 37.50 ppm |
Analyzer module controls...
I/O module controls...
Analyzer module setup...
I/O module setup...
Measure |
| Channel | Back... |
|
F1 | F2 | F3 | F4 | F5 |
From the menu "Expert Module Configuration" you can change to several submenus to set up parameters for the measurement and calibration of your analyzer and analyzer module. Besides you can set up the configuration for auxiliary modules. Which part of these menus are important for you depends on the configuration of your NGA 2000 system.
In the following table you will find a short overview about the contents of the menus:
Menu | Important Contents | Section/Page | ||
|
|
|
| |
Analyzer module controls... | Þ | See "Analyzer module setup" and note below! | ||
|
|
|
|
|
I/O module controls... | Þ | Configuration of the SIO and of the DIO's* | ||
|
| installed in a platform or |
| p. 83 - 98 |
|
| in an MLT analyzer (auxiliary I/O's) |
|
|
Analyzer module setup... | Þ | Measurement set up and control | ||
| Þ | Calibration set up and control |
| p. 3 - 82 |
| Þ | Configuration of the SIO and of the DIO's |
|
|
|
| installed in the MLT analyzer module |
|
|
|
| (Local SIO/DIO) |
|
|
| Þ | Programmable logic control (PLC) |
|
|
| Þ | Programmable calculators |
|
|
I/O module setup... | Þ | Set up for micro processor controlled | ||
|
| auxiliary I/O modules |
|
|
Note:
All submenus of "Analyzer module controls..." are the same like those of "Analyzer module setup...", if you use an MLT analyzer or analyzer module (resp. TFID analyzer or analyzer module)! If your analyzer is not such a type, the submenus of "Analyzer module controls..." and "Analyzer module setup..." will look different, partially. Look at the corresponding software manuals.
90003482(2)
NGA 2000 | 5 - 1 |