5.1 Analyzer Module Setup

5.1.1 Calibration Parameters

Main Menu — Analyzer and I/O-module expert configuration

↓

Analyzer module setup

↓

Calibration parameters

↓

TAG

37.50 ppm

-- Calibration Parameters --

Span gases...

Tolerances...

Calibration procedure setup...

Time controlled calibration...

Calibration...

Advanced calibration methods...

Zero gases...

Measure

 

Channel

Back...

 

F1

F2

F3

F4

F5

From the menu "Calibration Parameters" you can change to several submenus to set up the zero and span gas calibration parameters and to start the different calibration methods.

Change to the submenus:

¨Select the menu line you want with the ↓ -key or the − -key.

¨Change to the corresponding submenu with the 8 -key or the → -key.

Alternatives:

¨F1: Change to the single component display !

¨F3: Change to the other available channels of an MLT analyzer or analyzer module !

¨F4: Go back to the last menu page !

90003482(2) [NGA-e (MLT-Software 3.2.X)] 07/98

NGA 2000

5 - 5