♦Calibration failure alarm
♦Calibration failure error allowed
♦Calibration time out
♦Zero and span gas calibration of the ranges together or separately
♦Enabling/Disabling of the calibration adjustment limits
♦Set up of the zero gas concentration of each range
♦Set up of the NO and NOx span gas concentration of each range
You can also set up all these parameters in the menus "Calibration Gas List", "Calibration Parameters", "Response time/delay parameters" and "Range Settings". You can find the descriptions of these menus in the chapters 5.1.1 p.
With the F4 key (LAST) of the menu "Analyzer Parameter List" you can change to the menu page "Calibration Gases", where you can set up the NO and NOx span gas concentrations of each range. This menu page is the same page you will reach by pressing the F3 key (NEXT) several times.
90003749(1)
NGA 2000 | 5 - 25 |