Emotiva pmn manual Connection Diagrams, Stereo Connection, Bridged Subwoofer Connection

Connection Diagrams

Stereo Connection

This diagram shows the BPA-1 connected to 2 speakers in a stereo configuration. The crossover switch is in the FLAT position. Speakers can be 4-8 Ohms.

This connection diagram shows
a typical use of the BPA-1 in
a stereo configuration driving	This configuration delivers 75 watts into
one left channel and one right
channel speaker. This setup	each 4 Ohm speaker. You can also use 8
is ideal for a second zone or	Ohm speakers in this configuration.
whenever the main speakers in
the room are assembled in a 2
channel configuration.

Bridged Subwoofer Connection

This diagram shows the BPA-1 connected to 1 subwoofer in a bridged configuration. The LEFT input is the mono input for the bridged configuration and will come from your receiver or preamplifier’s sub- woofer output. The crossover switch is in the LOWPASS position. Crossover frequency should begin around 100Hz and be fine tuned once the system is playing as it depends on the frequency response of the other main speakers in your system. The subwoofer should be no less than 8 Ohms.

This connection diagram shows
a typical use of the BPA-1 in a	This configuration delivers 150 watts into
bridged configuration driving
a single subwoofer. This	a single 8 Ohm speaker. You MUST use
setup is ideal for non powered	a speaker with a minimum of 8 Ohms
subwoofers or the woofer	nominal impedance for the bridged
portion of a multi-element	configuration!
speaker that has bi-amp
capabilities.

Page 10