Wiring of ON/OFF/REMOTE Switch with 750 Millivolt Wall Thermostat Accessory and Another Accessory
Connect the green and red, stripped and bare, wires on the ON/OFF/ REMOTE switch wire harness to the 750 millivolt wall thermostat AND to the remote receiver that is a component in the
1.Connect (1) wire from the 750 millivolt wall thermostat and (1) wire from appropriate accessory to the GREEN, stripped and bare wire from the ON/OFF/REMOTE wire harness.
2.Connect (1) wire from the 750 millivolt wall thermostat and (1) wire from appropriate accessory to the RED, stripped and bare wire from the ON/OFF/REMOTE wire harness.
Note: When the appliance is in the MANUAL mode and the batteries fail in the
Manual Operation
1.Turn ON/OFF/REMOTE switch on wiring chase to REMOTE position.
2.Turn wall thermostat OFF.
3.Turn accessory,
Wall Thermostat Operation
1.Turn the ON/OFF/REMOTE switch on wiring chase to REMOTE position.
2.Turn accessory,
3.Turn wall thermostat ON and set appropriate temperature. Wall thermostat will cycle the appliance ON and OFF.
Installation of Remote Receiver (Figure 17)
1.Attach, from left to right, the
2.Push the receiver slide button onto the receiver slide switch. Reverse installation of the slide button if it is off center.
3.Attach velcro loop on the left side of the valve cover support.
4.Attach velcro hook onto remote receiver. The word TOP on the remote receiver should be to the top when installed onto valve cover support.
5.Attach velcro hook on remote receiver onto velcro loop on valve cover support..
Figure 17
Wiring Diagram (Figure 18)
.
Figure 18
PLEASE NOTE
It is normal for appliances fabricated of steel to give off some expansion and/or contraction noised during the start up or cool down cycle. Similar noises are found with your furnace heat exchanger or car engine.
Installation of Logs (Figure 19)
1.Remove screen front from inner body by removing (4) 1/2"
2.Remove logs from interior of inner body. Remove all protective packaging from logs and interior of inner body.
3.Align the two rear pins on the base with the two alignment holes on the underside of the rear log. Place the rear log onto the two rear pins on the base.
4.Align the two front pins on the base with the two alignment holes on the underside of the front log. Place the front log onto the two front pins on the base.
5.Align the two pins on the front log with the two alignment holes on the underside of the top log. Place the top log onto the two pins on the front log.
6.Replace and attach screen front onto inner body with (4) 1/2" hex- head screws from Step 1.
7.Installation of logs is completed.
Refer to Figure 19 for the following warning.
Warning: Failure to position the parts in accordance with this diagram or failure to use only parts specifically approved with this appliance may result in property damage or personal injury.
Page 12 |