WIRING
CIBV-30 ON/OFF/REMOTE Switch
Operation of ON/OFF/REMOTE Switch with no Accessories
To ignite main burner, turn the control knob on the gas valve from the PILOT position to the ON position. Turn the ON/OFF/ REMOTE switch from the OFF position to the ON position. The additional green wire and red wire, which are stripped and bare are not used.
Operation of ON/OFF/REMOTE Switch with Accessories 750 Millivolt Wall Thermostat
Connect the green and red, stripped and bare, wires on the ON/ OFF/REMOTE switch wire harness to the wall thermostat.Turn the ON/OFF/REMOTE switch on the wire channel to the REMOTE position. Set the wall thermostat to the desired temperature.
It is important to use wire of a gauge proper for the length of the wire:
RECOMMENDED WIRE GAUGES
Maximum | Wire |
Length | Gauge |
1' to 10' | 18 |
10' to 25' | 16 |
25' to 35' | 14 |
Wall Switch, FWS-1
Connect the green and red, stripped and bare, wires on the ON/OFF/REMOTE switch wire harness to the wall switch. Turn the ON/OFF/REMOTE switch on the wire channel to the REMOTE position. Pivot the rocker switch on the
Battery Operated Remote Control,
Note: If batteries fail in
Electric (120 volt) Operated Remote Control,
Note: If electric (120 volt) fails in
Wiring of ON/OFF/REMOTE Switch with 750 Millivolt Wall Thermostat Accessory and Another Accessory
Connect the green and red, stripped and bare, wires on the ON/ OFF/REMOTE switch wire harness to the 750 millivolt wall thermostat AND to the remote receiver that is a component in the
1.Connect (1) wire from the 750 millivolt wall thermostat and
(1)wire from appropriate accessory to the GREEN, stripped and bare wire from the ON/OFF/REMOTE wire harness.
2.Connect (1) wire from the 750 millivolt wall thermostat and
(1)wire from appropriate accessory to the RED, stripped and bare wire from the ON/OFF/REMOTE wire harness.
Note: When the appliance is in the MANUAL mode and the batteries fail in the
Manual Operation
1.Turn ON/OFF/REMOTE switch on wire channel to REMOTE position.
2.Turn wall thermostat OFF.
3.Turn accessory,
Wall Thermostat Operation
1.Turn the ON/OFF/REMOTE switch on wire channel to REMOTE position.
2.Turn accessory,
3.Turn wall thermostat ON and set appropriate temperature. Wall thermostat will cycle the appliance ON and OFF.
Page 18 |
|