Empire Products EE-25-2 Wiring, Oiling Blower Motor, Parts List, Index, Number, Description

OPTIONAL BLOWER INSTALLATION INSTRUCTIONS (continued)

Wiring

The appliance, when installed, must be electrically grounded in accordance with local codes or, in the absence of local codes, with the National Electrical Code ANSI/NFPA No. 70, if an external electrical source is utilized. This appliance is equipped with a three-prong [grounding] plug for your protection against shock hazard and should be plugged directly into a properly grounded three-prong receptacle. Do not cut or remove the grounding prong from this plug. For an ungrounded receptacle, an adapter, which has two prongs and a wire for grounding, can be purchased, plugged into the ungrounded receptacle and its wire connected to the receptacle mounting screw. With this wire completing the ground, the appliance cord plug can be plugged into the adapter and be electrically grounded.

CAUTION: Label all wires prior to disconnection when servicing controls. Wiring errors can cause improper and dangerous operation. Verify proper operation after servicing.

Oiling Blower Motor

The blower motor does not have oiling holes. Do not attempt to oil the blower motor.

WARNING:

Unplugging of blower accessory will not stop the heater from cycling. To turn off gas to the unvented heater: Push in gas control knob slightly and turn clockwise to "OFF." Do not force.

		PARTS LIST
Index	Part
No.	Number	Description
1	R-1468	Bushing
2	VF-153	Mounting Bracket
3	R-2695	Motor
4	R-2696	Fan Blade
5	R-2104	Fan Control
6	DV-806	Switch Box
7	DV-807	Switch Box Cover
8	R-2113	Spacer
9	R-896	Bushing
10	R-2091	Wire Assembly
11	VF-068	Cord Set

.

If any of the original wire as supplied with the appliance must be replaced, it must be replaced with type 125° C wire or its equivalent.

. .

Page 16 R-2688