| 36” min. from | |
6” Min from | ceiling | |
|
| |
adjoining |
|
|
walls |
|
|
|
|
|
Left
SideRight
Side
Floor
2” min. to top surface of carpet, tile or other combustible material
Figure 4
FASTENING HEATER TO WALL
Mounting Bracket
The mounting bracket in located on the back panel of heater (see figure 5). It has been taped there for ship- ping. Remove mounting bracket from back panel.
Figure 5
Mounting
Bracket
Removing Front Panel of Heater
1.Remove three screws on bottom front of front panel.
2.Pull bottom of front panel forward, then down (see figure 6)
Figure 6
Attaching Mounting Bracket to Wall
Use holes on each end of mounting bracket to attach bracket to wall. These holes are 16 inches apart. Attach mounting bracket to wall in one of two following ways.
1. Attach to wall studs
2. Attach to wall anchor
Attaching to Wall Stud:
This way is the best providing the strongest mounting in wood frame houses.
Attaching to Wall Anchor:
This way allows you to attach mounting bracket to hol- low walls (wall areas between studs) or to solid walls (concrete or masonry).
Decide which way best suits your needs. Either method will provide a secure hold for the mounting bracket.
1.Tape mounting bracket to wall where heater will be located. Make sure mounting bracket is level. For wall stud mounting locate one end of the mounting bracket over a wall stud.
WARNING: Maintain minimum clearances shown in figure 7. If you can, provide greater clearances from the floor and joining wall.
2.Mark screw locations on wall (see figure 7).
3.Remove tape and mount bracket from wall.
Wall |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
Adjoining |
| 16” (Lg) |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| ||
|
|
| |||||||
|
|
|
| ||||||
| Mark mounting hole locations | ||||||||
|
|
|
|
|
|
| |||
|
|
|
|
|
|
| |||
| and drill holes where indicated. |
|
|
|
|
|
| ||
| Allow for minimum clearances |
|
|
|
|
|
| ||
|
|
|
|
|
|
| |||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Figure 7
Attaching to Wall Stud:
For attaching mounting bracket to wall studs
1.Drill holes at marked locations using 9/64” drill bit.
2.Place mounting bracket onto wall. Line up holes on each end of bracket with hole drilled in wall.
3.Insert mounting screws through bracket and into wall studs.
4.Tighten screws until mounting bracket is firmly fastened to wall studs.
Attaching to Wall using Anchor:
For attaching mounting bracket to hollow walls (wall ar- eas between studs) or solid walls (concrete or masonry)
Note: Wall anchors, mounting screws, and spacer are in hardware package. The hardware package is provided with heater.
Unvented Liquid Propane Fired Room Heater | 6 | Installation Instructions and Owner’s Manual |
