Summer Shutdown
If you do not plan to use the heat pump pool heater during the summer months, secure and protect it as follows:
1.Turn the unit circuit breaker or disconnect switch to OFF.
2.Leave the valves set the way they are unless addi- tional circulation is required. DO NOT stop all flow through the heat pump pool heater.
3.IMPORTANT: Remember to reset the valves before the next heating season, or the unit will not operate properly.
Freeze Protection
If the unit is installed in a location subject to freezing conditions, it is important to protect the water circuit from freezing, just as should be done for the pump and filter.
System
1.Turn the unit circuit breaker or disconnect switch to OFF.
2.With the pool pump OFF, close the external shut- off valves and loosen the inlet and outlet water unions to allow water to drain. Use a Wet/Dry Vac or air pressure to remove excess water.
3.Loosely
4.Cover the unit with a waterproof cover.
Continuous Pump Operation
It is also possible in some areas to prevent unit freeze damage by operating the pump continuously during freezing weather. However, this results in significantly higher pump operating costs. Further, if a sustained power failure occurs, the unit MUST be drained any- way, or freeze damage could result.
Maintenance
NOTE: The heat pump pool heater MANUFACTUR- ER IS NOT RESPONSIBLE for maintenance adjustments.
The following maintenance procedures are designed to keep your unit operating at a high level of reliability.
Maintenance must be performed on a periodic basis to maintain warranty coverage and prevent system failures and performance degradation.
Air Coil Cleaning
Efficient operation depends on free circulation of air through the thin and
CAUTION: To clean the fins, spray gently with a garden hose. DO NOT pressure wash. Doing so will bend the fins and can void the warranty.
Cabinet Care (optional)
The cabinet is designed for outdoor use and requires little care. However, you can clean it if you wish.
WARNING: Shut OFF electricity to the unit before cleaning.
Wash the cabinet with soap and water.
Unplug Condensation Drain Holes
The unit extracts humidity from the air as it passes through the coil, similar to the way a cold drink outside “sweats” on a hot day. This condensation drains from the bottom of the unit.
1.Routinely check to be sure the condensation drain holes in the base of the unit are not plugged with dirt or debris.
2.If condensation becomes a problem, optional drain pans are available from your heat pump pool heater distributor or pool dealer.
13
