Installing a Remote Control Device on Analog Heaters
Wiring
For a 2-wire control, use the TOTAL and COMMON connections on the heat pump pool heater wiring block.
For a
Installing a Remote Control Device on Digital Heaters
Wiring
For a
For a
Fig. 10: Heater Wiring Block — Analog Heaters
Heater Settings
1.To operate the heater using a
2.To operate the heater using a
Fig. 11: Heater Wiring Block — Digital Heaters
Heater Settings
1.Make sure the heater is disabled on the remote control device. Then, push the SET key until POL is displayed. Push the DOWN arrow key until OFF is displayed. Wait until a temperature is displayed before beginning the next step.
2.Push the SET key until SPA is displayed, then push the UP arrow to 104°F. Wait until a tempera- ture is displayed before beginning the next step.
3.Push the SET key until P_S is displayed, then push the DOWN arrow until POL is displayed. Wait until a temperature is displayed before begin- ning the next step.
4.Finally, enable the heater on the remote control device. When there is a call for heat, the heater display will show SPA. When the heater is dis- abled, the display will show POL.
22