Energy Tech Laboratories MR212 manual Start-Up and Maintenance Documentation, Job Information

AirflowMaxitrol 14

Switchamplifier

Start-Up and Maintenance Documentation

START-UP AND MEASUREMENTS SHOULD BE PERFORMED AFTER THE SYSTEM HAS BEEN AIR BALANCED AND WITH THE HEAT ON (Warranty will be void without completion of this form)

Job Information

Job Name

Address

City

State

Zip

Phone Number

Fax Number

Contact

Purchase Date

Service Company

Address

City

State

Zip

Phone Number

Fax Number

Contact

Start-Up Date

Heater Information

Refer to the start-up procedure in this manual to complete this section.

Name Plate and Unit Information

Model Number

Serial Number

Motor Volts

Motor Hertz

Motor Phase

Motor FLA

Motor HP

Blower Pulley

Motor Pulley

Belt Number

Gas Type

Min. Btu/Hr

Max. Btu/Hr

Field Measured Information

Motor Voltage

Motor Amperage**
RPM
Burner Differential Pressure	in. w.c.
Pilot Flame Signal		VDC
Low Fire Flame Signal		VDC
High Fire Flame Signal		VDC
Gas Type
High Fire Inlet Gas Pressure	in. w.c.
Low Fire Manifold Gas Pressure	in. w.c.
High Fire Manifold Gas Pressure	in. w.c.
Thermostat Set-Point
Temperature Control	Discharge
	Space
Airflow Direction	Correct
	Incorrect

**If measured amps exceed the FLA rating on the nameplate, fan RPM must be reduced to decrease the measured amps below the nameplate FLA rating.

Maintenance Record

Date

Service Performed

Factory Service Department

Phone: 1-866-784-6900

Fax: 1-919-554-9374

28 May 2008 Rev. 11