Energy Tech Laboratories VEC1029FPOB Specifications, Battery Replacement/Disposal, Warnings

VEC1029FPOB_ManualEN_101606 10/16/06 5:17 PM Page 12

Fuse Replacement (12 Volt DC Charging/Power Adapter)

1.Remove plug from accessory outlet. Remove the gold cap by turning counter- clockwise and lifting off.

2.Remove center pin and spring. Remove fuse.

3.Replace fuse with same type and size fuse (8 amp).

4.Replace center pin and spring inside plug.

5.Replace gold cap by turning clockwise.

Battery Replacement/Disposal

It is recommended that the unit be returned to Customer Service for battery replacement.

This unit contains a maintenance-free, non-spillable, sealed lead-acid battery. This battery is fully recyclable and should be accepted at any location that accepts common automotive batteries. Examples of places

that accept these batteries are: county or municipal recycling drop-off centers, scrap metal dealers and retailers who sell automotive replacement lead acid batteries.

WARNINGS

Do not dispose of the battery in fire, as this may result in an explosion.

Before disposing of the battery, protect exposed terminals with heavy-duty electrical tape to prevent shorting (shorting can result in injury or fire).

Do not expose battery to fire or intense heat, as it may explode.

SPECIFICATIONS

12 Volt DC Specifications

Battery:	12 volt DC rechargeable, maintenance-free
Internal Battery Type:	Sealed, AGM lead-acid
Internal Battery Capacity:	12 volt, 19Ah/20 hour rate
Area Light :	Light Emitting Diode (LED)
Accessory Outlet Protection:	Self-resetting overload protection
DC Charging Adapter:	12 volt DC

AC Power Specifications

Output Power:	400 watts
Output Voltage:	120 VAC RMS
Output Frequency:	60 Hz ±4 Hz
Output Waveform:	Modified sine wave
Overheat Protection:	Yes
Overload Protection:	Yes
Output Short Circuit
Protection:	Yes

12