Energy Tech Laboratories VEC1029FPOB user manual Read This User’s Manual Before Using This Unit

Models: VEC1029FPOB

1 16
Download 16 pages 33.55 Kb
Page 3
Image 3
Read This User’s Manual Before Using This Unit.

VEC1029FPOB_ManualEN_101606 10/16/06 5:17 PM Page 2

c)Your location is out of range from a weather radio transmitter; the broadcast range from the weather radio transmitter is approximately 40 miles. The effective range depends on such things as terrain and quality of the receiver and indoor/outdoor antenna. Log onto http://www.nws.noaa.gov/nwr/nwrbro.htm to see which frequency best serves your area.

d)Metal structure; to improve the radio’s ability to receive NOAA broadcast; do not place the unit near any large obstructions or metal surfaces such as refrigerators, metal cabinets, etc. In metal structures, such as mobile homes, reception is difficult because the metal structure impedes the transmission of monitor waves, in this case, place the radio close to a window to improve reception.

e)Radio frequency interference; some electronics may cause radio frequency interference such as two- way radios, remote control cars, etc. Place the unit as far away as possible from these devices or avoid the usage of devices that cause radio frequency interference while the unit is in alert mode.

If there is excessive background noise while monitoring alerts; or when the alert comes on, adjust the volume using the Volume Control Knob or relocate the unit to a better location where you can hear the weather broadcast without risk of interference from background noise.

If you are out of audible range of or far away from the unit; or if there is an obstruction between you and the radio, be sure to check the unit for warnings periodically or remain close enough (within hearing range) to clearly hear and understand the alerts.

SAVE THESE INSTRUCTIONS WARNING: To ensure to continuously monitor alerts from NOAA while the unit is in alert mode, the unit should be checked periodically to confirm its functionality and for loss of reception; also check for loss of reception after moving the unit to a different location.

Test Warnings from NOAA; all National Weather Services periodically transmit test signals. Some stations broadcast a test signal every week on Wednesday between 11 AM and 1 PM, while others test more often, the NWS may also broadcast System demonstrations. You can find out when your local NWS broadcasts test signals by calling the NOAA National Weather Service Forecast Office (listed under “Weather” in the Federal Government section of the telephone book.) During the weekly test signal, the local NWS will give a list of counties covered by their transmitter.

Check unit periodically for wear and tear. Take to a qualified technician for replacement of worn or defective parts immediately.

Read This Instruction Manual Before Using This Unit.

Read This User’s Manual Before Using This Unit.

SAVE THESE INSTRUCTIONS

This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

Consult the dealer or an experienced radio/TV technician for help.

2

Page 3
Image 3
Energy Tech Laboratories VEC1029FPOB user manual Read This User’s Manual Before Using This Unit, Save These Instructions