REPLACING COMPONENTS
Vacuum Switch
1.Before beginning any component replacement, be certain the unit is unplugged and thoroughly cooled down.
2.Remove the right side panel and the back panel as previously detailed.
3.Locate the vacuum sensor as shown in the diagram below.
4.Disconnect the stove wiring harness and vacuum hose from the vacuum sensor, taking note of where connections were made.
5.Remove the two screws which hole the vacuum sensor to the vacuum sensor bracket using a 5/16” wrench.
6.Installation is the reverse of removal; be absolutely certain the wires and vacuum house are connected according to the wiring diagram in this manual.
Igniter
1.Before beginning any component replacement, be certain the unit is unplugged and thoroughly cooled down.
2.Remove the right side panel and the back panel as previously detailed.
3.Locate the igniter as shown in the diagram below.
4.Disconnect the igniter wiring from the control board and use a 5/16” wrench to remove the igniter retaining screw.
5.Loosen the allen set and remove the old igniter cartridge.
6.Install the new igniter in the igniter tube, retighten the set screw and reinstall the assembly into the stove. Be certain to reconnect the new igniter wires to the circuit board before reassembly.
Page 39
