![](/images/new-backgrounds/1118174/11817493x1.webp)
Connecting to Console Port for Local Management
4.Turn on the terminal and access the Setup Directory. Set the following parameters on your terminal:
Parameter | Setting | |
|
|
|
Mode | 7 | Bit Control |
|
| |
Transmit | Transmit=9600 | |
|
|
|
Bits Parity | 8 | Bits, No Parity |
|
| |
Stop Bit | 1 Stop Bit | |
|
|
|
When these parameters are set, the Startup screen will display. Proceed to Section 3.7 to complete the installation.
Figure 3-15 Connecting a VT Series Terminal
522
| 50 |
| 51 |
49 | 1 |
CPU RPS | 49 | 50 | 51 52 | 1 | 2 |
| Á | |
 | À | |
à | ||
3831_01_10 | ||
UTP | ||
RJ45 Console port shown on | VT series terminal |
3.6.4Connecting to a Modem
To connect a modem to an Enterasys Networks device modem port (Figure
1. | Connect the RJ45 connector at one end of the cable | to the Console port on the Enterasys |
| Networks device. |
|
2. | Plug the RJ45 connector at the other end of the cable | into the |
3. | Connect the | |
4. | Turn on the modem and make sure the remote modem is ON. |
Hardware Installation