Enterasys Networks manual ISSUES RESOLVED IN E9.1.7.0

ISSUES RESOLVED IN E9.1.7.0

ISSUES RESOLVED IN E9.1.7.0:

The following tables provide brief descriptions of the issues resolved in this release. E9.1.7.0 includes all issues resolved in the E9.0.7.7 System Firmware Maintenance Release (see the E9.0.7.7 Release Notes for details).

10-Gigabit	I.D.
Priority queue settings on the ER16-OS26-01 may cause the X-Pedition to experience ingress buffer	F4188
overflows.
Entering the port show mc-vlan-encapall-portscommand from the CLI erroneously displays the	F4319
ER16-OS26-01 system ports.

Access Control List (ACL)	I.D.
If a user applies multiple ACLs to a port, the acl show command may not display all of the ports in	F4115
the "Applied Port(s)" field.	F4357
When using the acl-edit<acl_name> command to edit ACL data, users cannot remove all	F4328
commands associated with the ACL from the active configuration without rebooting the router.

Advanced Routing Engine (ARE)			I.D.
The ARE learns MAC addresses from all forwarded AppleTalk packets. The ARE should learn MAC			F4142
addresses from AARP Response packets only.
The appletalk ping <address> command will fail if the target address belongs to an AppleTalk			F4147
interface on the same router that initiated the ping.
Border Gateway Protocol (BGP)			I.D.
Although the BGP Import policy filters routes correctly, these routes do not appear in the route table.			F4347
Command Line Interface (CLI)			I.D.
The system image command options use inconsistent naming schemes and may generate			F3609
messages that are unclear to users. Furthermore, default behavior varies between commands.
If a serial console session times out after the X-Pedition prompts the operator for a reply to a			F4272
command they entered, the router may core the next time the console is activated.
Negating or removing a command that contains a quoted string from the active configuration may			F4299
cause the router to core.
When a user adds commands to the CLI through a cut-and-paste operation, the router may display			F4325
the “more” prompt before the CLI finishes processing the commands.
When a user enters the copy active to scratchpad command from a CLI session, then closes the			F4387
session without issuing the logout or exit command, future CLI sessions will hang when attempting
to perform any operations that involve accessing the active configuration.
Users cannot select the unicast or multicast options with the ip-router policy import source and			F4448
ip-router policy aggr-gen destination commands.
Distance Vector Multicast Protocol (DVMRP)			I.D.
Clients attached to a DVMRP-enabled interface that is also an 802.2Q trunk port may see multicast			F4316
traffic requested by a client in a different VLAN that is also part of that trunk port.
10/02/03 P/N: 9038090-53	Subject to Change Without Notice	Page: 19 of 31
F0615-J