IBM PC/AT Systems

Symptom

Cause

Corrective Measure

 

 

 

 

 

The power will

The power is not connected to an outlet or

Insert the power plug securely in an outlet

computer.

or computer.

 

not turn on.

 

 

Nonstandard SCSI cable is used.

Use a standard SCSI cable.

The computer

 

 

 

 

 

Use a standard SCSI cable (6m or less in

hangs up at star-

The SCSI cable is too long.

length).

 

tup.

 

 

 

The settings for the SCSI board are not ap-

Revise the settings according to the SCSI

 

 

propriate.

board manual.

 

 

 

 

 

 

 

Loose connection in the SCSI connector.

Plug in the SCSI connector again.

 

 

 

 

 

 

 

The terminator is not activated.

Activate the terminator.

 

 

 

 

 

 

 

 

The same SCSI ID is assigned to another

Power off all the devices then change the

 

 

SCSI device.

 

 

SCSI ID.

 

 

 

 

 

 

 

 

 

 

A terminator is included in another hard

Remove the terminator or deactivate the

 

 

disk in a daisy chain connection.

terminator on the CD-10

 

 

 

EZ-SCSI is not installed.

Install EZ-SCSI according to the EZ- SCSI

 

 

manual. Check the CONFIG.SYS file for

The PC card

 

 

the proper setting.

 

 

 

 

 

 

 

Install ASPIDISK included in the attached

cannot be

ASPIDISK is not installed.

recognized.

floppy disk.

 

 

 

 

 

 

 

 

The card is not properly inserted.

Insert the card properly.

 

 

 

 

 

 

 

 

 

 

 

Troubleshooting

 

 

 

 

 

 

 

 

 

 

 

25

Page 27
Image 27
Minolta CD-10 instruction manual IBM PC/AT Systems, Symptom Cause Corrective Measure