Enterasys Networks XSR-Series manual Dialer Int. PRI to BRI with D-channel-callbackcentral-site

5.5.1 Dialer Int. PRI to BRI with D-channel-callbackcentral-site

XSR-central#show running-config

!!

!Version 6.0.0.9, Built Dec 12 2003, 14:56:30

hostname XSR-central

username remote1 privilege 0 password cleartext xsr1 username remote2 privilege 0 password cleartext xsr2

controller e1 0/1/0 pri-group

isdn bchan-number-order ascending no shutdown

dialer pool-member 1 priority 10

access-list 120 permit ip	any any
!

interface FastEthernet 1

ip address 10.20.30.1 255.255.255.0 no shutdown

!

interface Dialer0 multi-point dialer pool 1 encapsulation ppp multilink load-threshold 20 dialer caller 120 callback dialer caller 140 callback dialer-group 1

dialer map ip 1.1.1.2 120 dialer map ip 1.1.1.3 140

ip address 1.1.1.1 255.255.255.0 ppp authentication pap

ppppap sent-username central password xsr ppp multilink

no shutdown

!

ip router-id 1.1.1.1

!

ip route 10.10.10.0 0.0.0.255 1.1.1.2 ip route 20.20.20.0 0.0.0.255 1.1.1.3

!

router ospf 1

network 1.1.1.0 0.0.0.255 area 0.0.0.0 network 10.20.30.0 0.0.0.255 area 0.0.0.0

!

dialer-list 1 protocol ip list 120

!

end

XSR-central#

Note: Incoming calls may be mapped to a dialer interface based on the PPP authenticated username if the following conditions are met:

–Interface dialer 0 is needed for the desired PPP authentication (e.g., ppp authentication pap).

–The username must be configured under the dialer interface using the dialer remote-namecommand.

Configuration Guide Page 21 of 55