Installation
THERMOSTAT INSTALLATION:
A) HI / LOW:
When the jumper is placed on only one of the J9 pins, then the control board is in a HI / LOW mode of thermostat operation (factory setting).
B) ON / OFF:
If both pins of J9 are jumped (covered), the control board is in an ON / OFF mode of thermostat operation.
Remove jumper wire and install thermostat wires here
Figure 26: Circuit Board.
This control board can be placed into two different modes: When the jumper J9 is not jumped then the control board is in a HI / LOW mode operation. If the control board is placed with J9 jumped then the control board is in a ON / OFF mode of operation. In the ON /OFF thermostat mode, the unit will shut OFF when the thermostat is not calling for heat. When the thermostat calls for heat, the unit will go through an ignition sequence once again and relight.
1.Install the wall thermostat in a location that is not to close too the unit but will effectively heat the desired area.
2.Install a 12 or 24 Volt Thermostat using an 18 x 2 gauge wire from the unit to the thermostat.
If the unit has been placed in the HI / LOW mode, the unit will be taken to a low or idle setting when the thermostat is not calling for heat. When the thermostat calls for heat, the unit will go to the setting that is displayed on the control board Heat Indicator. If the heating load is not great enough when the stove is on low, the high limit switch will turn the stove off and the switch will have to be manually reset. To reset the high limit switch, remove the right cabinet side. The switch is found behind the control panel. Avoid setting off the high limit switch.
OPTIONAL SLIDER/DAMPER INSTALLATION: |
| |
If you wish to adjust the slider damper externally (NOT | Slider damper | |
REQUIRED), please follow the instructions below. | ||
rod and knob |
|
| 7/16" Nut |
|
| 7/16" Clinching Nut |
|
| Slider damper plate |
|
| Figure 27: Slider/Damper Assembly. |
Slider/ | 1. | To install the OPTIONAL slider damper rod, remove the left cabinet |
| side and locate the slider damper plate. Install the 7/16” inch nut | |
Damper |
| |
Knob |
| onto the slider damper rod, thread all the way to the end of the |
|
| threads on rod. |
| 2. | Slide rod through the hole in the slider damper plate and install |
|
| the 7/16” clinching nut onto the rod and tighten completely onto |
|
| the slider damper plate. |
Figure 28: Slider/Damper Knob. | 3. | |
|
| rod. Check slider damper for smooth operation. |
25
