Enviro EF3 owner manual Installation, This unit includes a 3” 75 mm pedestal

		Installation
INSTALLATION FOR A BUILT-IN HEATER:
Combustible			This unit includes a 3” (75 mm) pedestal
			and surrounding faceplates. The part of the
materials and
structure			unit behind the faceplate can be enclosed
			with combustible material. It has 1” (25
Surround Panel		Wall	mm) standoffs to establish clearances to
		thimble	combustibles to the back, top and sides.
		12"	Refer to “CLEARANCES TO COMBUSTIBLES - BUILT-IN
		(30.5 cm)
		45°	HEATER“ and Figure 12 and 13 for the size
			and placement of the alcove to be built for
		elbow
			the unit.
6"		Rodent	For the venting refer to “HORIZONTAL EXHAUST
(15 cm)		mesh cap	THROUGH WALL INSTALLATION - FREESTANDING“.
		Fresh air
		intake
Non-combustible		Existing floor
		(combustible)
floor protection.	3" (7.5 cm)
	Pedestal
Figure 32: Built-in heater installation.
INSTALLATION OF CONTROL PANEL INTO SURROUND PANEL - FPI AND BIH:

When installing the control panel into the surround panel, the surround does not need to be assembled. The control board will be found in behind the firebox.

Place the control panel on the backside of the right surround panel so the hinge is on the outside and the top and bottom holes on the control panel line up with those on the surround. Attach using two (2) T-20 screws through the front of the surround into the circuit board control panel.

After the surround has been assembled and is ready to be installed on the unit, plug the wiring harness into the control panel (see Figure 32).

Figure 33: Control

Panel Cover.

THE TUBE SCRAPER ROD:

����

Figure 34: Control

Panel Back.

Put the stainless steel rod through the hole in the heat exchanger located behind the top louvers. Thread the rod into the scraper plate, which is visible from inside the firebox by removing the top baffle.

Figure 35: Tube scrapper rod

placement.

26