Installation
REMOVAL:
When maintenance is required on the unit the surround must be removed. Follow steps 3 through 6 in reverse order.
The side panel can remain attached because they swing forward for easy access (refer to Figure 37).
SLIDER/DAMPER INSTALLATION:
���� ��������� |
����� ��� |
Figure 39: Side surround panel swings forward.
This is used to regulate the airflow through the pellet stove.
1.Remove the slider rod (short rod with knob and nuts) from their package and open the left side panel.
2.Remove the knob and outer nut from the knob. Push the rod through the hole in the slider. Place the lock nut on the rod and tighten, leaving a 1/32” (1 mm) gap between the slider and the other nut.
3.Make sure the slider moves freely. Close the side panel and tighten screws after placing the rod through the panel. Screw the knob onto the slider.
A Qualified Service Technician or Installer must set the Slider Damper. Taking a reading of vacuum pressure inside the firebox with a magnehelic gauge can be used to set the slider for best combustion. The slider damper should be set only on a hot stove (operating for 30 minutes or more) by placing a Magnehelic Pressure Gauge in the firebox (test port is located in the center of the stove just below the door opening). The best settings are a reading of 0.12 to 0.13 inches of water column (30 Pa) on the high fire setting. Some fuels may require higher or lower settings. The reading can be taken from the 1⁄8” (3 mm) hole located on the front of the unit below the door and behind the magnetic ash lip.
����� ����������� |
| ��� ������� |
| ����� | |
��� �� ��� |
| |
|
| |
|
|
|
|
|
|
���� �����
��������� ���
��� �������
������
����������� ���
�����������
�������
Figure 40: Slider / damper assembly.
28
