Mode not Supported | Envision Peripherals H712a manual

ERROR MESSAGE & POSSIBLE SOLUTION

1.Check that the signal-cable is properly connected , If the connector loose, tighten the connectors screws.

2.Check the signal-cables connection pins for damage.

Your computer has been set to unsuitable display mode ,set the computer to display mode given in the following table (See page 17).

Image 15

Contents

Table of Contents FCC Class B Radio Frequency Interference Statement Precautions Special Notes on LCD Monitors FeaturesChecking the Contents of the Package Before YOU Operate the Monitor Installation Instructions Power CordPower Source Connecting Cables AC Power Cord Sub Cable Audio Cable Controls and Connectors Video Cable Adjusting the Viewing Angle MENU/ENTER Operating InstructionsGeneral Instructions External Controls Front Panel Control  Power Button / Power Indicator /Volume  Auto Adjust button / Exit OSD Message HOW to Adjust a Setting Eeprom Adjusting the Picture OSD Plug and Play Plug & Play DDC2B Feature Technical Support FAQ Mode not Supported Error Message & Possible Solution Cable not Connected Specifications AppendixVesa DDC2B TM Menu Standard Resolution Horizontal Vertical Frequency Preset Display Modes PIN no Description Connector PIN Assignment