TROUBLESHOOTING
Most treadmill problems can be solved by following the steps below. Find the problem that applies, and follow the steps listed. If further assistance is needed, please see the front cover of this manual. PROBLEM: The power does not turn on
SOLUTION: a. Make sure that the power cord is plugged into a surge suppressor, and that the surge suppressor | ||
is plugged into a properly grounded outlet (see page 11). Use only a | ||
sor that meets all of the specifications described on page 11. IMPORTANT: The treadmill is not | ||
compatible with |
|
|
b. After the power cord has been plugged in, make sure that the key is inserted into the console. | ||
c. Check the power switch located on the treadmill | c |
|
frame near the power cord. If the switch protrudes as |
| |
shown, the switch has tripped. To reset the switch, | Tripped | Reset |
wait for five minutes and then press the switch back | ||
in. |
|
|
PROBLEM: The power turns off during use |
|
|
SOLUTION: a. Check the power switch (see the drawing above). If the switch has tripped, wait for five minutes and then press the switch back in.
b. Make sure that the power cord is plugged in. If the power cord is plugged in, unplug it, wait for five minutes, and then plug it back in.
c. Remove the key from the console. Reinsert the key into the console.
d. If the treadmill still will not run, please see the front cover of this manual.
PROBLEM: The console displays remain lit when you remove the key from the console
SOLUTION: a. The console features a display demo mode, designed to be used if the treadmill is displayed in a | |
store. If the displays remain lit when you remove the key, the demo mode is turned on. To turn off | |
the demo mode, hold down the Stop button for a few seconds. If the displays are still lit, see THE | |
INFORMATION MODE on page 18 to turn off the demo mode. | |
PROBLEM: The displays of the console do not function properly |
|
SOLUTION: a. Remove the key from the console and UNPLUG THE | a |
POWER CORD. Then, place the treadmill in the stor- | |
age position (see HOW TO FOLD THE TREADMILL | 1 |
on page 20). | |
Next, remove the two indicated #8 x 3/4" Screws (1). |
|
| 1 |
21
