2.Identify the Right Upright (92), which is marked with a “Right” sticker.
Have a second person hold the Right Upright
(92)near the Right Base Cover (102). See the inset drawing. Tie the wire tie in the lower end of the Right Upright securely around the end of the Upright Wire (93). Then, pull the other end of the wire tie in the top of the Right Upright until the Upright Wire is routed through the Right Upright.
Gently pull up on the Upright Wire (93) as you set the Right Upright (92) on the Base (103) in- side the Right Base Cover (102). Be careful not to pinch the Upright Wire.
Attach the Right Upright (92) to the Base (103) with two 3/8" x 3 3/4" Screws (5) and two 3/8" Star Washers (6). Note: It may be necessary to tip the top of the Right Upright forward slightly as you thread the Screws into it. Do not tighten the Screws yet.
Attach the Left Upright (91) in the same way. Note: There are no wires on the left side.
2
Wire
Tie
93 91
92
102
| 103 | |
| 6 | |
92 | 5 | |
93 | ||
| ||
| Wire | |
| Tie |
3. With the help of a second person, lower the | 3 |
| |
treadmill off the cardboard stand. The stand will |
| ||
|
| ||
be used again in assembly step 9. | 89 |
| |
|
| ||
Identify the Right Upright Sleeve (90) and the | 91 |
| |
"Left" | "Right" | ||
Left Upright Sleeve (89), which are labeled | |||
“Right” and “Left.” |
| 90 | |
|
| ||
Slide the Right Upright Sleeve (90) onto the |
|
| |
Right Upright (92), and slide the Left Upright |
|
| |
Sleeve (89) onto the Left Upright (91). |
| 92 | |
|
| Cardboard | |
|
| Stand | |
| 8 |
|
