Too many copies are printing.
Make sure the Copies settings in the printer software and your application aren’t both set for multiple copies.
Paper doesn’t eject fully or is wrinkled.
■If the paper doesn’t eject fully, you
may have set the wrong paper size. Press the E load/eject button to eject the paper. Then select the correct paper size in your application or printer software.
■If it’s wrinkled when it ejects, the paper may be damp or too thin.
Paper doesn’t feed.
Remove the stack of paper from the sheet feeder. Check that the paper:
■Isn’t curled or creased
■Isn’t too old
■Isn’t loaded above the arrow on the left edge guide
■Isn’t jammed inside the printer. (If the S paper out light is flashing, paper is jammed.)
When you reload the paper, make sure the left edge guide fits the paper, but not too tightly.
Paper jams inside the printer.
Turn off your printer, open the cover, and remove all the paper that’s inside, including any small pieces that may have torn off.
If your paper jams frequently:
■Use smooth,
■Fan the stack and then even the edges before loading it.
■Don’t load paper above the arrow mark on the left edge guide.
■Place the paper against the right edge guide and slide the left edge guide against your paper.
Multiple pages feed at once.
Remove the stack of paper from the printer. Then:
■Make sure the paper isn’t too thin.
■Fan the edges of the stack of paper to separate the sheets.
■Reload the paper as described on page 14.
■Make sure the edge guides fit against the paper, but not too tightly.
58