■Input Signal

Setting ! Input Signal

Adjust these settings for the type of equipment connected to the projector:

Video Signal: Leave this setting on Auto so the projector can automatically interpret the picture (only affects images displayed through the Video or S-Video port).

Input A: Change this setting to match the type of equipment connected to the Input A port. If necessary, check the label on your equipment to match the setting.

D4: Change this setting to match the type of equipment connected to the D4 port (used mainly in Japan).

■COM Port

Setting ! Operation ! COM Port

Select the type of cable you’ve connected to your PC or laptop for running the Cinema Color Editor software. Choose USB or RS-232C(for a serial cable).

■Trigger Out

Setting ! Operation ! Trigger Out

Turn on this setting if you want the Trigger out port to output a 12-volt signal while the projector is operating. You can use this to raise or lower your projection screen automatically.

■Sleep Mode

Setting ! Operation ! Sleep Mode

Turn off this setting if you don’t want the projector to enter sleep mode. (Sleep mode shuts the projector off automatically after 30 minutes when there is no video signal.) Leave the setting on to conserve power and extend the life of the lamp.

■Lock Setting

Setting ! Operation ! Lock Setting

Lets you lock the projector’s focus and zoom settings. Also lets you lock the buttons on the projector’s control panel, or set a child lock that makes it more difficult to turn on the projector. See page 25.

37