14 Operation
HP289
3.2.4 Auto Restart
The Batch Controller can be configured to continually repeat the batch
process. This mode of operation is selected during the configuration
process.
The process is started by pressing the RUN key whereby the normal
batch operation is commenced. After reaching the End-of-Batch (see
Section 3.2.3), the Batch Controller will then wait for a pre-
programmed period before automatically resetting and starting the
batch process again.
The STOP key can be pressed at any time to interrupt the batching
process and the process can be continued using the RUN key. If,
however, the process is to be aborted, the STOP key is pressed again.
The Batch Controller is reset and to restart the auto batching process
the RUN key is pressed.