2
Printing on Continuous Paper 2-23
R4C4620
Rev. C
A5 size CONT.FM
6/14/00 Pass 3
R
Proof Sign-off:
SEI Y.Ohkawara T.Takahashi
T.Takahashi
SEI M.Kauppi K.Blair
7. Set the paper release lever to the pull tractor position. Then
remove any slack in the paper between the push and pull
tractor using the micro adjust feature (described on
“Adjusting the Top-of-Form Position” on page 2-31.) if
necessary.
8. Move the pape r release lever back to the push tr actor position
you set in step 2.
9. When the printer receives data, it will start printing at the
current position. If necessary, follow the steps in “Adjusting
the Top-of-Form Position” on page 2-31 to adjust the current
position of the paper.
cCaution
❏Never use the knob to remove slack in the paper or to
adjust the top-of-form position; this may damage the
printer or cause it to lose the top-of-form position.
❏Always remove any slack from the paper; otherwise print
quality may be reduced.
10. Attach the paper guide. Then slide the edge guides to the
middle of the paper guide. Lift the center section of the paper
guide up and lay it flat.
11. A ttach the printer cover and close the paper guid e cover.
12. You may need to check and change the printer driver settings
as described in Chapter 4. Then send a print job to the printer.
The printer starts printing from the cu rrent position without
advancing the paper. The printed pages are fed over the paper
guide toward the back of the printer.