2
Printing on Continuous Paper 2-31
R4C4620
Rev. C
A5 size CONT.FM
6/14/00 Pass 3
R
Proof Sign-off:
SEI Y.Ohkawara T.Takahashi
T.Takahashi
SEI M.Kauppi K.Blair
Adjusting the Top-of-Form Position The top-of-form position is the position on the page where the
printer starts printing. If your printi ng appears too high or low
on the page, you can use the micro adjust feature to adjust the top-
of-form position. Follow these steps:
cCaution:
Never use the knob to adjust the top-of-form position; this may
damage the printer or cause it to lose the top-of-form position.
Note:
❏Your top-of-form position setting remains in effect until you change
it, even if you turn off the printer.
❏The top margin setting made in some application software overrides
the top-of-form position setting you make with the micro adjust
feature. If necessary, adjust the top-of-form position in your
software.
1. Make sure printer is turned on.
2. If necessar y, load paper as described earlier in this ch apter. If
you load paper onto the push tractor, pre ss the Load/Eject
button to advance the paper to the current top-of-form
position.
3. Lift the printer cove r up and off the printer.
4. Hold down the Pause button for about three seconds. The
Pause light starts flashing and the printer enters the micro
adjust mode.