Epson 28-293 instruction manual Accessories

BAND SAW BLADES

A bandsaw blade is a delicate piece of steel that is subjected to a great deal of strain. Proper blade care results in optimal performance. Always use blades of the proper thickness, width, and temper to correspond to the workpiece.

Use the widest blade possible. Narrow blades should be reserved for small, abrupt curves and delicate work.

When pressure is required to push a workpiece through the blade, either file and set the blade, or replace it. A broken blade can be welded or brazed, but if the blade has been work-hardened, it will soon break again. A good rule of thumb is to sharpen the blade after 4 hours of operation.

Band saw blades will break because of the peculiar stresses to which they are subjected. However, many blades break because the operator (1) does not check the alignment and adjust the guides; (2) forces or twists the blade around a short-radius curve; (3) feeds the workpiece too fast; (4) allows the blade to become dull; (5) tightens the blade tension excessively; (6) sets the top blade guide too high; (7) uses a blade that has been improperly brazed or welded; and/or

(8) runs the blade continuously when not cutting.

Blades for the standard 14" Band Saw are 93-1/2" long. The saw can adjust to a maximum length of 94" and a mini- mum of 91-1/2". If the saw is equipped with the accessory Height Attachment, the blades should be 105" long. Maximum and minimum lengths are 106" and 103-1/2".

OPERATING THE BAND SAW

CAUTION: DISCONNECT TOOL FROM POWER SOURCE.

Before starting the tool, make all adjustments and put all guards in place. Turn the upper wheel clockwise by hand to be sure that everything is correct prior to turning the tool on.

Keep the top guide close to the work. Do not force the material against the blade.

Light contact with the blade will permit easier following of the line and will prevent excess friction, heating, and work-harden- ing of the blade at its back edge.

Keep the saw blade sharp and very little pressure will be required for average cutting.

Avoid twisting the blade by turning abrupt corners.

CUTTING CURVES

When cutting curves, turn the stock carefully so that the blade may follow without being twisted. If a curve is so abrupt that repeated new kerfs are needed, then use either a narrower blade or one that has more set. The more set a blade has, the eas- ier the stock is to turn. However, the cut is usually rougher than when using a medium set.

When withdrawing the blade, be careful not to draw the blade off of the wheels. In most cases, it is easier and safer to turn the saw and saw out through waste material. Do not back the blade out while the saw is running.

ACCESSORIES

A complete line of accessories is available from your Delta Supplier, Porter-Cable • Delta Factory Service Centers, and Delta Authorized Service Stations. Please visit our Web Site www.deltamachinery.com for a catalog or for the name of your nearest supplier.

WARNING: Since accessories, other than those offered by Delta, have not been tested with this product, use of such accessories could be hazardous. For safest operation,only Delta rec- ommended accessories should be used with this product.

12