Connecting the Computer Cable
Follow these steps. You may not need to use the adapter as shown.
1.Disconnect the monitor cable from the video port on the back of the Macintosh.
2.Connect one end of the computer cable to the projector’s
Computer/Component Video port, as shown.
3.Connect the other end of the computer cable to the video port on the Macintosh.
4.If it doesn’t fit and you have a DVI port, you’ll need to use a DVI to VGA adapter. An adapter may have come with your computer. See your Macintosh documentation for instructions.
If it doesn’t fit and you have an older Macintosh, you may have to use a Macintosh desktop adapter, which you can buy from EPSON (see page 7).
To use the adapter, remove its cover as shown and set its DIP switches according to the resolution you want to use, such as
Replace the cover and connect the adapter to the free end of the computer video cable. Then plug the cable (with the adapter) into the video port on your Macintosh.
5. Tighten the screws on the connectors.
Appendix A: Connecting to Additional Equipment 71