note

You can also set up your image as a startup screen. Use the Advanced menu to enable the startup screen.

Assigning the Image to the No-Signal Message and/or A/V Mute Button

After your image is saved, you can set it up as the no-signal message and/or the screen that’s displayed when you press the A/V Mute button.

1.Press the Menu button. You see the main menu listing, with the Video menu highlighted.

2.Press the bottom edge of the Enter button (or tilt it down) to highlight the Setting menu.

3.Press the Enter button to select the Setting menu.

4.Press the bottom edge of the Enter button (or tilt it down) to highlight No-Signal Msg.

5.Press the right side of the Enter button to select Logo. This sets your image as the screen displayed when the projector is not receiving a signal.

6.If you want to set up your image as the A/V mute display, press the bottom edge of the Enter button (or tilt it down) to highlight A/V Mute.

7.Press the right side of the Enter button to select Logo. This sets your image as the screen displayed when you press the

AV/Mute button.

8.When you’re finished, press Esc or Menu.

To test your setting, press the A/V Mute button to display your image. Press it again to turn off the image.

Using the Projector Menus 29